CUTTING CREASING RULES
CENTER BEVEL
Bevel is the type of cutting edge geometry, facilitated to give desired cutting and creasing result to the end use of packaging industry. Center Bevel means, the cutting edge is at the center of the rule thickness.
Center Bevel edge is available in 42o and 52o. Choose any Bevel Angle suitable for your application.
SIDE BEVEL
Side Bevel is also available in both 42o and 52o
CENTER BEVEL LONG EDGE
This bevel type is also available in both 42o and 52o as Top Bevel cutting angle. This type of bevel is useful in cutting soft material like foam, leather, cloth etc.
THROUGH HARDENED RULES
Through hardened edge rules have same hardness at body and the edge.
EDGE HARDENED RULES
Only the Tip of the rule is hardened to maximum possible and the body of the rule is soft in order to achieve better bend-ability with suitable run length of rules.
CUTTING CREASING RULES
The Cutting Creasing Rules are available in through hardened type body with elliptical creasing edge profile to give desired creasing results in hardest possible board or paper. The bottom edge is flat base type with smooth chamfer on both sides to avoid any damage to the plywood boards at the time of fixing the rules.
PERFORATION RULES
The Perforation Rules are available as per the specifications given in the table below.
Thickness Bevel Spacing CUT / Non CUT Height
0.71 mm (2pt)
1.05 mm (3pt)

1.42 mm (4pt)
Center side
Center bevel
Long edge
1 : 1, 2 : 1, 3 : 1 21.3 mm to
25.4 mm
ZIPPER RULES
The Zipper Rules are available as per the specifications given in the table below.
Thickness Bevel Tooth Spacing Height Angled Ratio
0.71 mm (2pt)
1.05 mm (3pt)
Center 6mm, 8mm,
10mm, 12mm
21.3 mm to
25.4 mm
21.3 mm to
25.4 mm